BookTitleOkabe Product Catalog

Summary

Okabe Product Catalog

Separator JointJoint hardware for separators● Be sure to tighten the wedge until its bottomend is inserted further inside than the sleevebottom surface (See Fig. B).● Separator that cannot be inserted intothe sleeve, such as a hat-type separator,can be used by cutting.● Be sure to use the product within theallowable load or less.CautionsFeatures● Easy on-site adjustment with a wrench.● No welding required!① Insert two separators into the sleeve.(See Fig. A)② Slide two separators to obtain the necessarylength. (Secure at least 30mmfor excess length.)③ Tighten the wedge until its bottom endis inserted further inside than the sleevebottom surface. See Fig. B [Torque:3.43kN・cm (350kgf・cm) or more].◆Allowable load◆Usage instructionsProduct Quantity(pc/case)Weight(kg/case) PackingSeparator Joint W5/16 100 10Separator Joint W3/8 100 11 CaseSeparator Joint W1/2 50 10● For 5/16 12.0kN (1224kgf)●For 3/8 18.0kN (1836kgf)●For 1/2 24.0kN (2447kgf)Squeeze the sleeveas shown in the figureto insert the separatoreasilyFig. A When separators are inserted.Fig. B When tightening is completed.Keep the wedge not toexceed the surfaceWedgeNutWasherSleeveSeparatorTighten the hardware until the wedge bottomgoes inside the sleeve bottom surface.Slab JointerSeparator joint hardware from slab to wallSeparatorSeparatorProduct Quantity(pc/case)Weight(kg/case) PackingSlab Jointer 8 500 6 CaseSlab Jointer 9 500 13 CaseSlab Jointer 8 with nails ? ? ?Slab Jointer 9 with nails ? ? ?L-shaped Jointer N 500 11 CaseSlab JointerL-shaped Jointer◆Size Width between 2 sides 17Product No. B10-0550Product No. B10-056050